Quieto Siamp float valve | Ref: 10002302 | For built-in or surface-mounted tanks

Here is theQuieto Siamp float valvereference10 0023 02, for built-in and exposed porcelain tank.

By purchasing from my store, you reward my advice and content,
thank you🫶

Water level adjustment:
Your Quieto should already be installed in your empty tank. Lower its green tank as far as possible without removing it completely, turn on the water, then adjust the water level using the gray rod that extends from the float valve. At the top of this rod, you have a dial:

• If you turn it clockwise, you raise the water level.
• If you turn it counterclockwise, you lower the water level.
• Pulls mini-flush toilets to refresh the water level.
  

When the water stops where you want it to (usually at the old limescale mark), turn off the water, empty your tank, and place the tank under the float. Be careful, the tank must not lift the float. Finish by turning the water back on.

Facility :
If you already have an identical Quieto Siamp float valve in your tank, you can swap them without touching the plumbing by unscrewing the white nut. It's plug and play, leak-free, and 100% compatible.

Repairability:
This float valve is designed to provide access to the membrane, allowing for repair of the float valve.

The tank fills very slowly:
If your tank takes a long time to fill, you need to replace theaquastop float valve membrane. It's probably torn. If your float valve is in poor condition, such as encrusted with limescale, you may want to consider replacing it entirely.

The filling does not stop:
The problem is probably with the membrane.

Limestone:
When the float valve is too encrusted with limescale, it can become jammed and no longer perform the up-and-down movements of the float correctly. I advise you to clean it thoroughly or replace it if it is in really bad condition.

We'll keep in touch ;)
Stan